Search
Skip to Search Results- 137WISEST Summer Research Program
- 137WISEST Summer Research Program/WISEST Research Posters
- 10Graduate and Postdoctoral Studies (GPS), Faculty of
- 10Graduate and Postdoctoral Studies (GPS), Faculty of/Theses and Dissertations
- 2Mechanical Engineering, Department of
- 1Chemical and Materials Engineering, Department of
- 1Ayranci, Cagri (Mechanical Engineering)
- 1Daneshmand, Mojgan (Electrical and Computer Engineering)
- 1Dr. Cagri Ayranci (Department of Mechanical Engineering)
- 1Dr. David Nobes (Department of Mechanical Engineering)
- 1Henein, Hani (Materials Engineering)
- 1Mertiny, Pierre (Department of Mechanical Engineering)
-
A Fully 3D Printed Waveguide and its Application as Microfluidically Controlled Waveguide Switch
DownloadFall 2016
Hollow rectangular waveguides are employed extensively in microwave and millimeter wave devices owing to their relatively high power handling capabilities and low losses, particularly at higher frequencies, compared to transmission lines. However, the fabrication of such metal waveguides suffer...
-
2021-08-11
Katie Walline, Dr. Lisa Willis
The biological differences between males and females are significant yet too often overlooked. In research and clinical studies, sex differences are often not taken into consideration. However, glycobiology and immunology are starting to shift. Recent studies in glycobiology show that male and...
-
2021-08-12
Estefania Santos, Eric Lepp, Ahmed Samir Ead, Jason Carey
This project focuses on the design of an above the knee prosthetic lining made up of a natural and a synthetic fiber using a braided composite approach. Prosthetic linings are a part of an artificial limb that the amputee puts on their residual leg to protect the skin from any type of lacerations...
-
Additive Manufacturing of Shape Memory Polymers: Effects of Print Orientation and Infill Percentage on Mechanical and Shape Memory Recovery Properties
DownloadFall 2017
Material Extrusion Additive Manufacturing (MEAM), also known as Fused Deposition Modeling (FDM), is a manufacturing technique in which three-dimensional objects are built. These objects are built by repeatedly extruding thin layers of molten materials through a nozzle in different paths and...
-
2021-08-16
Blaire Buchan, Dr. Rafiq Ahmad, Rabiya Abbasi
For my project in the 2021 Summer Research Program I designed an aeroponic potato pot. The task given was designing a small aeroponic pot that could be used domestically and tuber roots (ex: yam, potato) were going to be the niche purpose for the aeroponic pot. This choice was made because when...