Search
Skip to Search Results- 178WISEST
- 93SRP
- 91STEM
- 41Women in Scholarship, Engineering, Science, and Technology
- 27Engineering
- 253D printing
- 9Gibbins, Howard
- 5Guillette, Lauren M.
- 5Konhauser, Kurt
- 4Ahmed Samir Ead
- 4Carey, Jason
- 4Chang, Scott
- 179WISEST Summer Research Program
- 179WISEST Summer Research Program/WISEST Research Posters
- 20Graduate and Postdoctoral Studies (GPS), Faculty of
- 20Graduate and Postdoctoral Studies (GPS), Faculty of/Theses and Dissertations
- 5Mechanical Engineering, Department of
- 3Mechanical Engineering, Department of/Progress in Canadian Mechanical Engineering, Volume 5
- 173Conference/Workshop Poster
- 20Thesis
- 7Conference/Workshop Presentation
- 6Article (Published)
- 1Article (Draft / Submitted)
- 1Learning Object
-
A Fully 3D Printed Waveguide and its Application as Microfluidically Controlled Waveguide Switch
DownloadFall 2016
Hollow rectangular waveguides are employed extensively in microwave and millimeter wave devices owing to their relatively high power handling capabilities and low losses, particularly at higher frequencies, compared to transmission lines. However, the fabrication of such metal waveguides suffer...
-
2021-08-11
Katie Walline, Dr. Lisa Willis
The biological differences between males and females are significant yet too often overlooked. In research and clinical studies, sex differences are often not taken into consideration. However, glycobiology and immunology are starting to shift. Recent studies in glycobiology show that male and...
-
2021-08-12
Estefania Santos, Eric Lepp, Ahmed Samir Ead, Jason Carey
This project focuses on the design of an above the knee prosthetic lining made up of a natural and a synthetic fiber using a braided composite approach. Prosthetic linings are a part of an artificial limb that the amputee puts on their residual leg to protect the skin from any type of lacerations...
-
Additive Manufacturing of Shape Memory Polymers: Effects of Print Orientation and Infill Percentage on Mechanical and Shape Memory Recovery Properties
DownloadFall 2017
Material Extrusion Additive Manufacturing (MEAM), also known as Fused Deposition Modeling (FDM), is a manufacturing technique in which three-dimensional objects are built. These objects are built by repeatedly extruding thin layers of molten materials through a nozzle in different paths and...