Search
Skip to Search Results- 1Abraham, Tinu M
- 1Adegoroye, Adebukola
- 1Chan, Margo Chi Wing
- 1Chong, Jeng Yi
- 1Darius, Juan
- 1Dogru, Oguzhan
- 8Xu, Zhenghe (Chemical and Materials Engineering)
- 3Liu, Qingxia (Chemical and Materials Engineering)
- 3Masliyah, Jacob (Chemical and Materials Engineering)
- 2Kresta, Suzanne (Chemical and Materials Engineering)
- 2Liu, Qi (Chemical and Materials Engineering)
- 2Masliyah, Jacob H. (Chemical and Materials Engineering)
-
Fall 2018
Canada has the third largest oil reserves in the world where 97% of these reserves are located in the oil sands, Alberta province. The product resulted from the extraction of oil sands reserves is called bitumen which can be diluted and shipped to the market or it can be proceeded and upgraded...
-
Spring 2021
At different stages during the extraction of bitumen from the Athabasca oil sands, the removal of unwanted fine solids whether suspended in aqueous or non-aqueous liquids continues to present serious challenges to the oil sands industry. These fine solids are unique in that their colloidal...
-
Spring 2010
The technique of Inverse Gas Chromatography (IGC) was employed for the study of the interactions between various organic solvents with various types of the major inorganic materials (clay minerals and sand) found in Alberta’s oil sands. Heat of adsorption (-∆H) was measured for each solvent with...
-
Spring 2015
A multi-purpose settling column was designed to determine settling rate and sediment height allowing the in-situ measurement of yield stress and drainage without disturbing the sediment particle network. The settling column was applied to studying flocculation/densification of model oil sands...
-
Spring 2013
The surface mining of oil sand ore requires the use of huge shovels and 400-tonne capacity trucks to transfer the mined ore to the slurry preparation plant, where water and additives are added to the crushed ore. The oil sand slurry is then transported to the extraction section and simultaneously...
-
Conduction and Dielectric Relaxation Mechanisms in Oil Sands Influencing Electrical Heating
DownloadFall 2016
Electrical heating has been proposed in the past as an alternative to conventional water based thermal methods for reducing viscosity of bitumen in oil sands reservoirs. This could reduce or even eliminate water use and associated problems like inefficient heat transfer in the reservoir, poor...
-
Fall 2010
The effect of slurry conditioning on bitumen recovery and bitumen froth quality has been studied by using three oil sands ores tested with a laboratory hydrotransport extraction system (LHES) and a Denver flotation cell. Tests with the LHES show that an increase in slurry conditioning time...
-
Spring 2019
This research aims to improve oil sands tailings treatment by applying a combination of quick lime (calcium oxide) and anionic or cationic polymers in the flocculation process. A procedure including mixing lime, dilution of mature fine tailings (MFT) in the lime supernatant and addition of...
-
Fall 2016
Non-aqueous solvent extraction of bitumen from oil sands has the potential to replace the existing hot-water extraction process. The benefit of non-aqueous extraction process includes high bitumen recovery, reduction of fresh water demand for extraction and the elimination of resulting tailing...
-
Spring 2016
Canada has the world’s largest oilsands reserves. Part of the reserves is being considered as marginal and is not profitable to recover using current technology. Autoxidation (oxidation with air) is a potential upgrading strategy to produce more valuable products from the oilsands derived bitumen...