Search
Skip to Search Results- 1Aldhaleai, Ahmed Mahmood
- 1Badiozamani Tari Nazari, Mohammad Mahdi
- 1Baker, Kathleen E.N.
- 1Beier, Nicholas A
- 1Bozorg Bigdeli, Masoud
- 1Brown, Lisa D
-
Spring 2012
Tailing ponds in Northern Alberta has covered an area of 170 km2. Directive 074 issued in 2009 set stringent criteria for tailings reclamation. Freeze-thaw dewatering is one of the most promising approaches for dewatering MFT as one cycle of freeze-thaw can release up to 50% pore water. In this...
-
Spring 2013
The mining of oil sands ore and extraction of bitumen produces aqueous slurries containing bitumen, coarse sand and fine clays. The performance of key process units is highly dependent on the rheology of “carrier fluid”, which is comprised of the fine solids and water. Although viscosity is...
-
Fall 2017
The focus of the research presented here was to directly measure actual evaporation rates from a tailings surface using a micrometeorological technique known as the eddy covariance method. Depending on the results, it would be determined whether current drying models need to be calibrated with...
-
Methane Production and Emission Mitigation in Oil Sands Tailings Concurrent with Hydrocarbon Degradation under Nitrogen Limited Conditions
DownloadFall 2020
Alberta’s oil sands generate large volumes of tailings from bitumen ore processing. These tailings ponds produce biogenic methane, which can be measured across 60-80% of the tailings surface. Based on current surface area data and emissions studies, tailings ponds could account for 8% of Canada’s...
-
Morphological Effects of Water Soluble Polymer Flocculants Synthesized by Controlled Reversible-Deactivation Radical Polymerization for Treatment of Mature Fine Tailings
DownloadFall 2020
The bitumen reserves in Northern Alberta are a valuable asset, but extracting bitumen from oil sands via the Clark hot water process produces undesirable waste tailings. These tailings are transported to tailings ponds where the sand and clay particles are left to settle slowly, creating a...
-
Spring 2017
Oilsands tailings are a waste product comprising primarily a stable alkaline suspension of clay in water. This waste product of oilsands mining is environmentally hazardous to store and expensive to safely dispose of. This work presents two novel ideas for dealing with the waste. The first is...
-
Spring 2010
Commercial Magnafloc 1011and in-house synthesized Al-PAM were used as flocculants for model tailings, laboratory extraction tailings and tailings from paraffin froth treatment unit. The polymers were tested for their flocculation ability in settling and filtration. For model tailings, both...
-
Protecting Worker Safety in Alberta by Enhancing Hazard Identification and Control for Hazards Associated with Tailings Facilities, Dams, and Systems
DownloadSpring 2019
My research was motivated by a fatality that occurred at an oil sands tailings operation on January 19, 2014, when a worker drowned in an underground cavern which formed under a leaking tailings transport system. At the time of the incident, the organization and workers did not know that ground...
-
Fall 2018
The production of a tailings waste stream is ubiquitous to mining and mineral processing operations, especially in Alberta’s oil sands industry. Due to the presence of colloidal clays such as kaolinite, which do not naturally sediment in suspension, water recycling and land reclamation remain...
-
Fall 2016
Non-aqueous solvent extraction of bitumen from oil sands has the potential to replace the existing hot-water extraction process. The benefit of non-aqueous extraction process includes high bitumen recovery, reduction of fresh water demand for extraction and the elimination of resulting tailing...