Search
Skip to Search Results- 1325Department of Chemical and Materials Engineering
- 3Department of Biomedical Engineering
- 2Department of Biological Sciences
- 2Department of Laboratory Medicine and Pathology
- 1Department of Civil and Environmental Engineering
- 1Department of Human Ecology
- 2Bendrich, Michelle
- 2El-Thaher, Nayef
- 2Fadic Eulefi, Anton
- 2Hoseinzadeh Hejazi, Sayed Alireza
- 2Hosseininejad, Seyed Shaham Aldin
- 2Karkooti, Amin
- 44Xu, Zhenghe (Chemical and Materials Engineering)
- 40Huang, Biao (Chemical and Materials Engineering)
- 34Liu, Qingxia (Chemical and Materials Engineering)
- 27Henein, Hani (Chemical and Materials Engineering)
- 27Zeng, Hongbo (Chemical and Materials Engineering)
- 20Gupta, Rajender (Chemical and Materials Engineering)
-
Spring 2011
Bitumen recovery by the water-based extraction process produces waste streams known as tailings. When discharged into the tailing ponds, the coarse solids in the tailings stream settle out quickly, while the fine solids accumulate over years of settling to a solids content of 30-35% by weight....
-
Spring 2020
The main objective of the present study is to experimentally and numerical studies of hydrodynamic cavitation phenomenon in the Venturi tubes, in order to validate and further develop numerical multiphase flow models with the obtained data. To achieve this, a visible experimental set-up was...
-
Spring 2021
The weld bead width and the penetration depth are major parameters that determine the mechanical strength of the weld joint. The analytic models, such as the Gaussian heat source model, may provide quite accurate estimations for the weld width and penetration; however, the model does not account...
-
Fall 2017
Casing pipes used in sour service are prone to two forms of failure: hydrogen induced cracking (HIC) and sulfide stress cracking (SSC). The objective of this thesis is to investigate the resistance of L80 ERW and Seamless steel pipe, with five different chemical compositions, to both HIC and SSC....
-
Fall 2011
Molecular dynamics simulations were performed to investigate hydrogen interaction with edge dislocations during deformation in α-Fe. In particular, uniaxial tensile tests at different hydrogen concentration were conducted in a single crystal iron with high density of edge dislocations introduced...
-
Fall 2021
The outer shell of firefighter protective clothing is prepared from high performance polymer fibers such as Kevlar®, Nomex®, PBI, PBO and LCP. They are designed to withstand extreme temperatures and provide protection against service hazards to firefighters. However, these fabrics show continuous...
-
Spring 2020
There is an increasing need of clean renewable energy sources to address the growing problems of greenhouse gas emission, global warming and climate change. The rapid consumption of fossil fuel resources has also contributed to toxic emissions and raised a question on sustainability of present...