Search
Skip to Search Results- 2Kannan, Rangasayee
- 1Ali, Mostafa A A
- 1Desalegne, Admasu S.
- 1Dewar, Matthew P
- 1Duong, Eric
- 1Fisher, Gary
- 15Graduate and Postdoctoral Studies (GPS), Faculty of
- 15Graduate and Postdoctoral Studies (GPS), Faculty of /Theses and Dissertations
- 2Civil and Environmental Engineering, Department of
- 2Civil and Environmental Engineering, Department of/Structural Engineering Reports
- 1Chemical and Materials Engineering, Department of
- 1Chemical and Materials Engineering, Department of/Research Articles and Materials (Chemical and Materials Engineering)
-
2018-01-01
Kennedy, J.R., Wiskel, J.B., Ivey, D.G., Henein, H.
The potential exists to use ultrasonic shear velocity for real time microstructure assessment of the quenching step in the teat treatment of L80 steel pipe. L80 steel samples were austenitized and subsequently cooled in different quench mediums (water, oil, heated oil, air and furnace) to produce...
-
Fall 2021
Newer energy codes for buildings in Canada now require energy losses associated with thermal bridging in smaller components to be accounted for. In masonry cavity wall systems, most of the energy losses from thermal bridging are due to structural penetrations at floor levels located at the shelf...
-
Modeling of the Effect of Run-out Table Cooling on the Microstructure of a Thick Walled X70 Skelp
DownloadSpring 2018
This thesis presents work performed to model and measure the effect of run-out table cooling on a thick walled X70 steel. During run-out table cooling, the steel undergoes several phase transformations that will affect its microstructure, and thus, its mechanical properties. To predict the steel...
-
Spring 2020
ML80 and Grade 483 are heat treatable steels, produced by a quench and temper process, that are used in the oil and gas industry. The development of the microstructure during heat treatment is important to ensure that the correct properties are achieved for these steels. However, a real-time...
-
Spring 2013
20Cr-32Ni-1Nb stainless steel alloys are commonly used in hydrogen reformer manifolds for transporting hot hydrogen by-products at 750-950 celcius. After long periods of exposure, embrittling secondary carbides and intermetallic phases can precipitate at the grain boundaries which can drastically...
-
The Role of Sulfur Species in Establishing the Corrosion Reactions in Refinery Metallurgies
DownloadSpring 2016
This thesis is focused on the studying the role that model sulfur-containing molecules have in corrosion reactions on relevant metallurgies. This was done by using a design of experiments where a number of sulfur-based compounds were reacted with various metallurgies. The 8 model sulfur compounds...
-
Spring 2019
The formation of bainite is the most studied and the most debated phase transformation in steels, with research spanning almost a century. With two theories of transformation, the transformation mechanism of bainite is still a disputed subject among physical metallurgists. Upper bainite and lower...
-
Spring 2012
Coped beams are susceptible to fatigue cracking in the web at the cope radius when subjected to tension in the coped region. Use of an adhesively bonded composite patch over the crack can reduce the stress concentration and delay further crack growth. This report contains the results of a...
-
Fall 2023
Steel fabricators and connection designers in the building construction industry often rely on traditional connection design methods, which involve using connection design software or spreadsheets to simulate and design connections with the goal of minimizing costs associated with fabrication and...
-
Fall 2017
Casing pipes used in sour service are prone to two forms of failure: hydrogen induced cracking (HIC) and sulfide stress cracking (SSC). The objective of this thesis is to investigate the resistance of L80 ERW and Seamless steel pipe, with five different chemical compositions, to both HIC and SSC....