Search
Skip to Search Results- 1Cornejo Garcia, Ivan
- 1Fadic Eulefi, Anton
- 1Hosseininejad, Seyed Shaham Aldin
- 1Montilla Pérez, César A
- 1NIEN, TENG-WANG
- 1Reza, Md Omar
- 3Nikrityuk, Petr (Chemical and Materials Engineering)
- 2Hayes, Robert (Chemical and Materials Engineering)
- 1 Hayes, Robert E. (Chemical and Materials Engineering )
- 1Ghaemi, Sina(Chemical Engineering)
- 1Gupta, Rajender (Chemical and Materials Engineering)
- 1Hayes, Robert E. (Chemical and Materials Engineering )
-
Fall 2019
Vega Mesquida, Ileana Magdalena
The rise in motor vehicle ownership has become not only an environmental issue, but also a public health threat as pollutants emitted negatively affect human health (Deng et al., 2017). One such pollutant is particulate matter, which has been regulated by a variety of countries because it...
-
Fall 2019
This work is devoted to CFD-based numerical studies of oil separation from sand particles under the influence of water flow velocity. A single micro-scale (diameter of 100nm) particle is covered by a thin oil film which is immersed in a uniform flow. The oil-particle separation has been modeled...
-
Spring 2016
Hosseininejad, Seyed Shaham Aldin
To overcome the challenges of low recovery of fine particles in flotation processes, designing a cavitating device that can enhance the recovery has been a major topic of study. In the design of a cavitating device, the bubble/bubble interactions, bubble response to the change of local pressure,...
-
CFD Modelling of Bioprocesses: Integrating Mechanical Mixing, Aeration and Dynamic Rheology
DownloadFall 2021
Sadino Riquelme, Maria Constanza
Bioprocesses currently have a huge importance in worldwide sustainable development. However, the design of bioreactors based on experimental and empirical knowledge poses a challenge for the industrial biotechnology. Thus, CFD has gained attention as a design tool. Although CFD modelling has...
-
Fall 2017
Current oil sands mining and bitumen extraction methods produce a significant amount of tailings. Recent legislation in Alberta aims to guarantee operators treat their tailings and reclaim them 10 years after the end of mine life. Since 2012, oil sand companies have spent more than $1.3 billion...
-
Fall 2012
Underground Coal Gasification (UCG) is a process in which coal is converted to syngas in-situ. UCG has gained popularity recently as it could be used to extract energy of deep-lying coal seams, and it reduces the footprints attributed to the gasification process. In this study, two models have...
-
Fall 2022
Complex concentrated slurry flows in horizontal pipelines are widely seen in many industries for transportation of solid particles or process wastes. i.e., tailings. Slurry flows can occur in a turbulent regime, and the carrier fluid usually shows a non–Newtonian behavior. Understanding the flow...
-
Fall 2015
This work is devoted to the CFD analysis of multiphase flow using Euler-Euler model. In particular, Euler-Euler multiphase model is applied to study numerically the behaviour of gas-solid system and solid-liquid system. The main objective of this work is to validate Euler-Euler multiphase model...
-
Experimental Investigation on the Turbulence of Particle-Laden Liquid Flows in a Vertical Pipe Loop
DownloadSpring 2016
The turbulent motion of particles and their interactions with the turbulence of the carrier phase make a complex system. Hence understanding the physics and consequently developing a well-stablished model becomes very difficult. With insufficient computational power to numerically resolve all the...
-
Spring 2020
The main objective of the present study is to experimentally and numerical studies of hydrodynamic cavitation phenomenon in the Venturi tubes, in order to validate and further develop numerical multiphase flow models with the obtained data. To achieve this, a visible experimental set-up was...