Download the full-sized PDF
Permanent link (DOI): https://doi.org/10.7939/R3DN9J
This file is in the following communities:
|Geotechnical and Geoenvironmental Engineering Program|
This file is in the following collections:
|Journal Articles (Geotechnical & Geoenvironmental Engineering)|
Analysis of foundation deformations beneath the Syncrude tailings dyke Open Access
- Author or creator
Morgenstern, N. R.
Chan, D. H.
- Additional contributors
Effective stress modeling
- Type of item
- Journal Article (Published)
Abstract: The paper presents the results obtained in the finite element simulation of 8 years of construction of a section of Syncrude's tailings dyke, which is located in northern Alberta and has been used to store oil sand mining waste. The site investigation for the construction of this dyke indicated that a region of the foundation contained a presheared, overconsolidated clay shale lying practically horizontal at about 20 m depth. Significant horizontal displacements have occurred along this layer. The section analyzed in this work is the one which showed the largest horizontal movements in the foundation. High pore pressures have been measured along this section, and the lateral displacements measured in the foundation have reached values over 25 cm. The major purposes of the finite element analyses were to identify the factors that have significantly influenced the deformation mechanisms and to determine a combination of parameters, within the acceptable range of values for each material, that would reproduce satisfactorily the field observations. Linear, nonlinear, and effective stresses analyses were carried out. The total stress analyses underestimated the displacements measured in the field very significantly. The displacements calculated by the effective stress analyses are in very good agreement with the measured values, and the combination of parameters necessary to reach those results are within the acceptable range of variability for each material involved, based on laboratory test results. The interpolation of the pore pressures based on the piezometer measurements and their incorporation into the analyses as known quantities at each stage of the loading process was found to be relatively simple and efficient, causing a substantial improvement of the results compared with the total stress analyses.
- Date created
- License information
- © 1994 NRC Research Press (Canadian Science Publishing). This version of this article is open access and can be downloaded and shared. The original author(s) and source must be cited.
- Citation for previous publication
Alencar, J., Morgenstern, N. R., & Chan, D. H. (1994). Analysis of foundation deformations beneath the Syncrude tailings dyke. Canadian Geotechnical Journal, 31(6), 868. DOI: 10.1139/t94-103.
- Link to related item
- Date Uploaded
- Date Modified
- Audit Status
- Audits have not yet been run on this file.
File format: pdf (Portable Document Format)
Mime type: application/pdf
File size: 2106535
Last modified: 2015:10:12 12:29:33-06:00
Filename: Analysis of Foundation Deformations Beneath the Syncrude Tailings Dyke.PDF
Original checksum: e065d04c7e0ae8fba4a887e08c401705
Well formed: true
Page count: 52