Search
Skip to Search Results- 1Afshar, Shima
- 1Aghaie, Ermia
- 1Ashrafizadeh, Sayed Hossein
- 1Baker, Kathleen E.N.
- 1Bhushan, Vivek
- 1Borle, Steven D
- 23Department of Chemical and Materials Engineering
- 13Department of Civil and Environmental Engineering
- 7Department of Mechanical Engineering
- 5Department of Renewable Resources
- 4Department of Earth and Atmospheric Sciences
- 1Chemical and Materials Engineering
- 4Li, Dongyang (Chemical and Materials Engineering)
- 4Mendez, Patricio (Chemical and Materials Engineering)
- 2Driver, Robert (Civil and Environmental Engineering)
- 2Ulrich, Ania (Department of Civil and Environmental Engineering)
- 2Zeng, Hongbo (Chemical and Materials Engineering)
- 1Amit Kumar (Mechanical Engineering)
-
Spring 2012
It is difficult to join high strength alloy steel which are produced by thermo mechanical controlled processing and get overmatched properties on the welds and heat affected zone (HAZ) when submerged arc welding (SAW) is used as joining process. Circumferential welds made in the mill to join...
-
Tarring the Oil Sands: The Evolution and Emergence of ENGO Opposition in Alberta’s Oil Sands and Social Movement Theory
DownloadFall 2012
ABSTRACT: The Alberta oil sands represent tremendous economic growth and prosperity for Alberta and Canada but their development does not come without cost. Environmental Non-Governmental Organizations (ENGOs), specifically the Pembina Institute and Greenpeace, have brought significant attention...
-
Spring 2017
Magnesium remarkably deserves considerable interest from industry especially transportation sector because of its high strength to weight ratio. However, poor wear resistance and low corrosion resistance of magnesium are barriers to extend use of its alloys. Yttrium is one of rare-earth elements...
-
Spring 2012
This work is focused on development of tungsten carbide-based materials as alternative anodes for direct utilization of methane in solid oxide fuel cells (SOFCs). Not only were the capabilities of the anodes highlighted, but the challenges were also stressed. First, the impact of porous support...
-
Turbidity Mitigation in an Oil Sands End Pit Lake through pH Reduction and Fresh Water Addition
DownloadFall 2016
The remediation of oil sands wastes such as fluid fine tailings (FFT) and oil sands process-affected water (OSPW) are of increasing concern in the oil sands industry. End pit lakes are one remediation option currently being researched at commercial scale in Base Mine Lake (BML) operated by...
-
Fall 2011
Various pressures of compressed air were introduced into the flame spraying torch and the protective coatings of nanostructured and conventional titania (TiO2) were deposited on low carbon steel substrates. Performance of the coatings was studied using scanning electron microscopy (SEM), hardness...
-
Fall 2010
Ductile steel plate shear walls are an established lateral load resisting system. Past research indicates that cold-rolled infill panels less than 1 mm in thickness present one solution to an overstrength problem arising from selecting an infill panel thickness based on ease of welding and...