- Stress Concentration in Built-Up Steel Members
- Wokem, Christian
- Stress concentration, fatigue
- Apr 21, 2010 9:41 PM
- Adobe PDF
- 3203664 bytes
- In the past riveting was commonly used for connecting steel structures, such as bridges. These fasteners usually develop a low and unreliable level of pretension such that the joints are assumed to behave like bearing type connections. Under cyclic loading, and depending on the stress concentration around the fastener holes, fatigue failure can occur at nominal stresses significantly lower than in members with no stress concentration. The current design standards account for this by calculating the stress range on the net section and using fatigue category B and D to assess the fatigue life for bolted and riveted details respectively. The net area used for the calculation of the stress range is based on the procedure proposed by Cochrane (the s2/4g rule), which is adequate shear type failure. Tests have shown, however, that the Cochrane approach does not apply for fatigue failure since rupture does not take place in a ductile shear mode. An investigation into the effect of connection size and hole pattern on the fatigue resistance of built-up I section to gusset plate connections was carried out. A design equation that considers the connection size and hole layout on the stress concentration factor is proposed. An appropriate fatigue category for these members is also recommended.
- Master of Science
- Department of Civil and Environmental Engineering
- Fall 2010
- Gilbert Grondin (Civil and Environmental Engineering)
Gilbert, Grondin (Department of Civil & Environmental Engineering)
Samer, Adeeb (Department of Civil & Environmental Engineering)
Chong, Qing Ru (Department of Mechanical Engineering)
Theses and Dissertations Spring 2009 to present
Department of Civil and Environmental Engineering
Apr 29, 2014 12:03 PM
Jun 28, 2012 3:32 PM
Delete your item from era
Do you really want to delete "Stress Concentration in Built-Up Steel Members" ?
Resotre your item to era
Do you really want to restore "Stress Concentration in Built-Up Steel Members" ?
Purge your item from era
Do you really want to permanently delete "Stress Concentration in Built-Up Steel Members" ?
Remove your item from era
Do you really want to remove "Stress Concentration in Built-Up Steel Members" ?