Search
Skip to Search Results- 1325Department of Chemical and Materials Engineering
- 3Department of Biomedical Engineering
- 2Department of Biological Sciences
- 2Department of Laboratory Medicine and Pathology
- 1Department of Civil and Environmental Engineering
- 1Department of Human Ecology
- 2Bendrich, Michelle
- 2El-Thaher, Nayef
- 2Fadic Eulefi, Anton
- 2Hoseinzadeh Hejazi, Sayed Alireza
- 2Hosseininejad, Seyed Shaham Aldin
- 2Karkooti, Amin
- 44Xu, Zhenghe (Chemical and Materials Engineering)
- 40Huang, Biao (Chemical and Materials Engineering)
- 34Liu, Qingxia (Chemical and Materials Engineering)
- 27Henein, Hani (Chemical and Materials Engineering)
- 27Zeng, Hongbo (Chemical and Materials Engineering)
- 20Gupta, Rajender (Chemical and Materials Engineering)
-
Spring 2016
The Capstone Design Course instructional team was selected to participate in the digital learning initiative at the University of Alberta. The goals of this initiative are to increase student engagement and promote flexible, independent learning. The objectives of the instructional team were to...
-
Investigating acid-catalyzed biomass reactions and solvent effects in humins formation, using multiscale molecular modeling
DownloadFall 2023
The conversion of lignocellulosic biomass to produce chemicals has gained significant interest recently. A broad spectrum of specialty chemicals can be obtained from lignocellulose-derived molecules. One of the most promising reactions in this category is the dehydration of cellulose-derived...
-
Spring 2022
Micron-size particle suspensions are very common in industrial processes such as mineral extraction and wastewater treatment. These particles are difficult to separate from the fluid media due to their size. The formation of aggregates increases the effective size of these particles, increasing...
-
Fall 2015
Carbon dioxide capture using adsorption based separation processes has shown promise but has not been exploited to full potential to be implemented on a commercial scale. This thesis examines two key stages in the development of adsorption based carbon dioxide capture processes, namely adsorbent...
-
Investigation and Optimization of Corrosion-resistant Electroless Ni-P Coating in Steam-assisted Gravity Drainage System
DownloadFall 2020
The boosting energy demand has propelled the increasing utilization of oil and gas resources, but severe corrosion occurs on traditional carbon steel materials. Driven by the harsh service conditions in steam-assisted gravity drainage system (SAGD) operations, a promising corrosion-resistant...
-
Spring 2019
In oil sands extraction, the removal of heavy materials from a bitumen feed is often facilitated by solvent addition treatment processes. These processes mix solvent with bitumen feed to cause the precipitation of heavy products. The settling properties of these heavy products as they separate...
-
Plasma Transferred Arc Additive Manufacturing Using 17-4 Precipitation Hardened Stainless Steel
DownloadSpring 2021
Plasma transferred arc additive manufacturing (PTA-AM) is a newly developed additive manufacturing (AM) process for the manufacturing of large industrial parts for the resource sector. A common material used in numerous industries is 17-4 precipitation hardened (PH) stainless steel, mainly due...
-
Fall 2011
The removal of solid particulates from crude oils and hydrocarbon streams is a common challenge in refining. Finding a method for efficient removal of the suspended solids in the oil streams is the main objective of this work. Paraffinic and aqueous treatment and the combination of these two...