Search
Skip to Search Results- 1Afshar, Shima
- 1Aghaie, Ermia
- 1Baker, Kathleen E.N.
- 1Brandon, Jordan T
- 1Brown, Daniel M.
- 1Chen, Huanchen
-
Spring 2013
Removal of a drop from its substrate may be gradually (e.g. evaporation) or all at once (e.g. shedding). In this thesis, drop adhesion force as a base for understanding the all at once removal of a drop from its substrate, and drop evaporation in room temperature as one of the gradual removal...
-
Fall 2017
The present research was conducted with the intent of evaluating the degradation of OCTG (Oil Country Tubular Goods) steel used in SAGD (Steam Assisted Gravity Drainage) applications, and developing a promising surface modification method and a novel composite coating using a technique that will...
-
Spring 2019
This thesis aims to demonstrate the feasibility of using System Dynamics (SD) techniques to develop a transparent, open-source and reproducible model capable of simulating long-term soil water dynamics in a tailings-cap system subject to upward flux from a consolidating tailings substrate. The...
-
Spring 2016
Non-aqueous extraction technologies are currently being investigated as an alternative to the conventional water based process for extracting bitumen from oil sands. The reduced dependence on fresh water and land for creation of tailing ponds makes non-aqueous technologies a greener alternative....
-
Spring 2015
The minable oil sands extraction process can be understood on a scale of a single oil sand grain. When the oil sand ore is mixed with warm water, each sand granule is initially covered with bitumen film which ruptures under the composite effect of shear and interfacial forces, while water...
-
Boxed-in: Comparing Algorithms for Box-flight Mass-Balance Greenhouse Gas Flux Measurements from Mineable and In Situ Oil Sands Developments
DownloadSpring 2022
To combat global warming, Canada has committed to reducing greenhouse gases (GHGs) 40-45% below 2005 emission levels by 2025. Monitoring emissions and deriving accurate inventories are essential to reaching these goals. GHGs can be measured at a small scale, often using ground measurements which...
-
Possible thunderstorm modifications caused by the Athabasca oil sands development and the Canadian Shield
DownloadFall 2017
Thunderstorms are common in boreal forest regions and can cause dangerous hazards such as lightning, forest fires, hail, wind, and flooding. Significant research has been conducted to help predict thunderstorms to mitigate or avoid the hazards and damage. The development of thunderstorms...
-
Fabrication and Characterization of Photolithographically Patterned Rough Surfaces Demonstrating Extreme Contact Angle Behavior
DownloadFall 2014
This thesis features experimental work done to fabricate and characterize silicon surfaces patterned using photolithographic techniques, both standard and novel, to produce a variety of surfaces with roughness of controlled geometric properties. In specific, one set of the surfaces fabricated...
-
Spring 2013
A major barrier to reclamation after oil sands mining is lack of commercially available, diverse native plant seeds and propagules for revegetation. Potential of LFH (forest floor material) developed on coarse textured soil for establishing native plants and how salvage, placement and storage...
-
Mimicking the Behaviors of Oil Contaminated Clays Using Functionalized Silica Nanoparticles
DownloadSpring 2018
Fine sand and clay particles arise naturally in diverse industrial and environmental remediation contexts. Organic compounds for example from oil production or oil spills can adsorb on their surface and influence their oil water interfacial behaviors. To isolate the impact of contamination and...