ERA

Download the full-sized PDF of Analysis of Phase Behavior for Steam-Solvent Coinjection for Bitumen RecoveryDownload the full-sized PDF

Analytics

Share

Permanent link (DOI): https://doi.org/10.7939/R3J960M5P

Download

Export to: EndNote  |  Zotero  |  Mendeley

Communities

This file is in the following communities:

Graduate Studies and Research, Faculty of

Collections

This file is in the following collections:

Theses and Dissertations

Analysis of Phase Behavior for Steam-Solvent Coinjection for Bitumen Recovery Open Access

Descriptions

Other title
Subject/Keyword
Phase behavior
Distillation
Bitumen recovery
Dimethyl ether (DME)
Steam-solvent coinjection
Type of item
Thesis
Degree grantor
University of Alberta
Author or creator
Sheng, Kai
Supervisor and department
Okuno, Ryosuke (University of Texas at Austin)
Leung, Juliana (Department of Civil and Environmental Engineering)
Examining committee member and department
She, Yuntong (Department of Civil and Environmental Engineering)
Okuno, Ryosuke (Department of Civil and Environmental Engineering)
Leung, Juliana (Department of Civil and Environmental Engineering)
Li, Huazhou (Department of Civil and Environmental Engineering)
Department
Department of Civil and Environmental Engineering
Specialization
Petroleum Engineering
Date accepted
2016-08-18T09:50:53Z
Graduation date
2016-06:Fall 2016
Degree
Master of Science
Degree level
Master's
Abstract
Steam-solvent coinjection, if properly implemented, can improve the bitumen recovery efficiency of steam-only injection methods, such as steam-assisted gravity drainage (SAGD). Previous studies have shown that steam-solvent coinjection can reduce residual oil saturation lower than that of SAGD. However, the phase behavior of reservoir fluids during steam-solvent coinjection has not been studied systematically to understand the enhanced displacement efficiency in steam-solvent coinjection. The main objective of this research is to develop a thermodynamics tool to explain the enhanced displacement efficiency obtained by steam-solvent coinjection compared to SAGD. Isobaric ternary phase behavior of water/bitumen/solvent is analyzed to give a general classification method for solvent-containing reservoir fluids. Then, the mechanism of enhanced displacement efficiency by steam-solvent coinjection is explained in a unified way based on the systematic phase behavior study of reservoir fluids. The unified explanation incorporates the phase behavior study of reservoir fluids, mass transfer of the volatile components in reservoir fluids from liquids to vapor, and phase transitions. Finally, the unified explanation of distillation is applied to dimethyl ether (DME), a solvent that has not been studied for steam-solvent coinjection. Two types of phase behavior can be defined for water/bitumen/n-alkane systems for steam-solvent coinjection. For Ternary Type 1, a solvent-rich oleic phase may separate from a bitumen-rich oleic phase in the vicinity of chamber edge, resulting in inefficient dilution of bitumen with the solvent. In contrast, Ternary Type 2 does not show the oleic phase separation, which indicates more effective dissolution of the solvent in bitumen. At 35 bars with the specific bitumen studied, n-C4 and lighter alkanes are classified as Ternary Type 1, and those heavier than n-C4 are classified as Ternary Type 2. Dimethyl ether is classified as a Ternary Type 1 solvent using the same classification scheme. It is found that Ternary Type 1 n-alkanes can yield lower residual oil saturations than Ternary Type 2 n-alkanes under the same operation conditions. Analysis on distillation based on the thermodynamic tool indicates that the enhanced displacement efficiency because of distillation is a result of temperature increase and competition between water and solvent to evaporate. Coinjection of steam with a solvent that has a larger temperature increase during the distillation and is more volatile relative to water can achieve a lower residual oil saturation. Coinjection of steam and DME through the analytical study shows its possible advantage over C3, which is an alkane similar to dimethyl ether in terms of vapor pressure. Compared to C3, DME has a smaller temperature increase for distillation, higher chamber edge temperature, higher displacement efficiency, and lower solvent retention. However, more research is required for more experimental data and modeling to investigate the applicability of DME. The novelties of this research reside in the following items. The phase behavior classification and visualization of water/oil/solvent phase behavior is effectively used to explain the distillation mechanism and solvent dilution in steam-solvent coinjection. The analytical solution developed in this research is a first thermodynamics tool to estimate the displacement efficiency in steam-solvent coinjection, without performing numerical simulation. This research also gives a preliminary study of steam-DME coinjection.
Language
English
DOI
doi:10.7939/R3J960M5P
Rights
This thesis is made available by the University of Alberta Libraries with permission of the copyright owner solely for the purpose of private, scholarly or scientific research. This thesis, or any portion thereof, may not otherwise be copied or reproduced without the written consent of the copyright owner, except to the extent permitted by Canadian copyright law.
Citation for previous publication

File Details

Date Uploaded
Date Modified
2016-08-18T15:50:55.626+00:00
Audit Status
Audits have not yet been run on this file.
Characterization
File format: pdf (PDF/A)
Mime type: application/pdf
File size: 4775373
Last modified: 2016:11:16 13:21:45-07:00
Filename: Sheng_Kai_201608_MSc.pdf
Original checksum: bd533b3f757a16d78df35abb59734834
Activity of users you follow
User Activity Date