Download the full-sized PDF of Colloidal Phenomena in Relation to Non-Aqueous Bitumen ExtractionDownload the full-sized PDF



Permanent link (DOI):


Export to: EndNote  |  Zotero  |  Mendeley


This file is in the following communities:

Graduate Studies and Research, Faculty of


This file is in the following collections:

Theses and Dissertations

Colloidal Phenomena in Relation to Non-Aqueous Bitumen Extraction Open Access


Other title
Interfacial tension
force measurement
Oil sands
Type of item
Degree grantor
University of Alberta
Author or creator
Mirmontazeri, Leylisadat
Supervisor and department
Liu, Qi (Chemical and Materials Engineering)
Yeung, Anthony (Chemical and Materials Engineering)
Examining committee member and department
Choi, Phillip (Chemical and Materials Engineering)
Chou, Keng (Chemistry)
Zhang, Hao (Chemical and Materials Engineering)
Tang, Tian (Mechanical Engineering)
Department of Chemical and Materials Engineering
Chemical Engineering
Date accepted
Graduation date
Doctor of Philosophy
Degree level
The non-aqueous extraction process involves dilution of mined oil sand with an organic solvent (the “diluent”), followed by separation of unwanted materials (clays, silica sand, connate water, etc.) from the diluted bitumen. The main focus of this research is on the removal of fines solids from organic liquids, with particular emphasis on the interfacial science behind the process. Two possible scenarios were proposed for the removal of the solids: (a) through aggregation of the solids with one another (i.e. homo-aggregation), and (b) through attachment of the solids to water droplets (i.e. hetero-aggregation); both mechanism are to occur in non-aqueous environments. The study of homo-aggregation was conducted on both macroscopic and microscopic length scales; the methods of investigation were, respectively, sedimentation test and the micropipette technique. It was discovered that the inter-particle forces were strongly dependent on the aromatic content of the diluent. This, we speculate, was due to the conformations of the bituminous molecules that were adsorbed on the solid surfaces. In particular, when in an aromatic environment, the adsorbed molecules are highly extended, thus forming steric barriers which prevent aggregation of the solids (via van der Waals attraction). It was also discovered that the rate of settling of the solids was strongly correlated with the adhesive force between the particles; the latter was measured using a micro-cantilever technique that was developed for this research. For example, in a purely aromatic diluent, the inter-particle force was zero; the fine solids were stabilized and settled as individual particles. Thus, aromatic diluents are detrimental to homo-aggregation. In the study of hetero-aggregation (i.e. attachment of solids to water droplets in non-aqueous liquids), the opposite was observed: it was the aliphatic diluent that created suppression of aggregation. The reason, which we discovered in this research, was due to a “rigid skin” that was created at the oil-water interface (i.e. the water droplet surface); this was likely due to the accumulation of colloidal asphaltene precipitates at the interface. We further demonstrated that addition of sodium naphthenates (SN), a class of surfactants indigenous to bitumen, could prevent formation of the rigid skin. However, SN had also the effect of significantly lowering the oil-water interfacial tension, which in turn weakened the solid-water attachment force. We have also examined the role of aliphatic solvents in particle sedimentation. It was discovered that, although the precipitation of asphaltenes would suppress homo-aggregation of the unwanted solids, the “network” of precipitates was capable of trapping the particles, which led to their separation — albeit at a slower rate compared to that by homo-aggregation. (This study provided the first mechanistic insight into the so-called “paraffinic froth treatment” process that is widely employed in the oil sands industry.)
Permission is hereby granted to the University of Alberta Libraries to reproduce single copies of this thesis and to lend or sell such copies for private, scholarly or scientific research purposes only. Where the thesis is converted to, or otherwise made available in digital form, the University of Alberta will advise potential users of the thesis of these terms. The author reserves all other publication and other rights in association with the copyright in the thesis and, except as herein before provided, neither the thesis nor any substantial portion thereof may be printed or otherwise reproduced in any material form whatsoever without the author's prior written permission.
Citation for previous publication
Mirmontazeri, L., S. Afshar, and A. Yeung, Evaluation of naphthenic acids as a soil remediation agent: A physicochemical perspective. Fuel, 2014. 128: p. 1-6.

File Details

Date Uploaded
Date Modified
Audit Status
Audits have not yet been run on this file.
File format: pdf (PDF/A)
Mime type: application/pdf
File size: 3190725
Last modified: 2015:10:12 17:21:27-06:00
Filename: Mirmontazeri_Leylisadat_201409_PhD.pdf
Original checksum: 170b37f3524372fae8336bb26b986ea7
Activity of users you follow
User Activity Date